Ignition unit for CX500.

We suppose that you have original unit as on picture below.


We can offer you our ignition DCCDIP2 with connector adapter (plug and play connection). You will only have to connect one more wire from ignition to +12V key switched. You can see our unit for CX500 on picture below.


There are more windings on CX500. Our ignition needs +12V from battery and signal from two double pickups. It doesn't need HV coil that is most common cause of problems. It doesn't need also advancer pulser. It does need only all pickups OK. Below is picture for check of pickups (check only red marked points).


Our unit can work with stator G08: G08 in Electrex
In this case you have to ground our unit directly (using blue wire in 8pin connector). Original stator grounding unit, G08 do not grounding it.

Process of connection unit you can see here: DCCDIP2 to CX500 connection
Connection manual download is here: Connection manuals
Unit will be preprogrammed for work on CX500.

Offer for customers inside EU (price with VAT):
ignition unit DCCDIP2 206 EUR).
connector adapter (7 EUR).
Freightage DPD, DHL (depended to destination 13-43 EUR).
Recommended accessories is USB/COM cable for connection to PC (15 EUR). USB/COM cable is useful for engine tuning and also it can serves with on-line monitor in setting software as diagnostic tool.

Offer for customers outside EU (price without VAT):
ignition unit DCCDIP2 (190 USD).
connector adapter (7 USD).
Freightage DHL (depended to destination - USA is 52 USD, Australia is 65 USD).
Recommended accessories is USB/COM cable for connection to PC (14 USD). USB/COM cable is useful for engine tuning and also it can serves with on-line monitor in setting software as diagnostic tool.

Payment method is bank transfer or card payment or PayPal. If you send us your delivery address we will send you invoice. We will also need your phone number for forwarder.